|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
The Technics manual was very clear and I was able to solve my technical problems.
I did not think that anyone kept these manuals and was pleasantly surprised to find them on the Internet and at an affordable price.
I would recommend Owner Manuals as a first source of technical products for ‘dated’ equipment manuals.
Ian
;
The content of the manual was not found on the Internet and was a hard find. I check the net for 5 hours until I came across this web-site. When I did find the book it Auto loaded into my IPAD PDF shelf for books for review at anytime. Overall I am satisfied with the book and it answered all my questions. This repair book is obsolete because the product I bout it for is pretty old. Thanks for the help with the download and even having the manual. Thanks 73's K5HRD
;
Excellent manual including schematics. The service was great and the manual helped complete the job.
;
It was magic after so many years to still be able to source this info. It was equally amazing to return my Pioneer receiver to it near new sound quality AFTER NEARLY 30 YEARS! Thank you for this ability!
;
Very quick and easy website to use and fast download of manual, quality of manual is excellent and will be pleased to use this service again in the future, thanks so much!
HOW TO TAKE OUT FRONT GRILLE Please follow below steps to take out front grille if necessary such as when servicing. Remove the Grille from the chassis. 1. Set the up-and-down air direction louver to open position (horizontally) by finger pressure.
10.3. OUTDOOR UNIT
10.3.1. SELECT THE BEST LOCATION (Refer to �Select the best location� section) 10.3.2. INSTALL THE OUTDOOR UNIT
2. Open the three screw covers as shown in the illustration below.
� After selecting the best location, start installation according to Indoor/Outdoor Unit Installation Diagram. 1. Fix the unit on concrete or rigid frame firmly and horizontally by bolt nut. (ø10 mm). 2. When installing at roof, please consider strong wind and earthquake. Please fasten the installation stand firmly with bolt or nails.
3. Remove the five mounting screws. 4. Open the front panel and remove a mounting screw at the centre. (Refer Diagram below) 5. To remove the Grille, pull the lower left and right side of the grille towards you (slightly tilted) and lift it straight upwards (Two tabs on the top inside edge of the grille are clear of their slots).
10.3.3. CONNECTING THE PIPING
Connect Piping to Indoor Please make flare after inserting flare nut (locate at joint portion of tube assembly) onto the copper pipe. (In case of using long piping) Connect the piping � Align the center of piping and sufficiently tighten the flare nut with fingers. � Further tighten the flare nut with torque wrench in specified torque as stated in the table.
REMOTE CONTROL NO. SWITCH 1. When installing two air conditioners in one room, each air conditioner can be synchronized to the remote controller. 2. In order to operate separately, open the rear cover of one of the remote controller and set the switch to �B�. 3. Also, set the remote control No. switch to �B� in the corresponding indoor unit. (The switch is located in the control box-sub. of the indoor unit.) Connect the Piping to Outdoor Unit 1. Align the center of the piping and sufficiently tighten the flare nut with fingers. 2. Finally, tighten the flare nut with torque wrench until the wrench clicks. � When tightening the flare nut with torque wrench, ensure the direction for tightening follows the arrow on the wrench.
|
|
|
> |
|
